This paper considers the present state of mathematical geology. Three directions are recognized: applied, theoretical, and mathematical. Applied mathematical geology includes formal use of mathematics to solve problems and computer processing of data. Success is achieved by a correspondence of mathematical methods used to the nature of geological data. This correspondence can be demonstrated by purely mathematical means. Theoretical mathematical geology uses mathematics as a language of geology; however, a number of methodological problems must be solved: formalization of initial geological concepts and creation of a strict conceptual basis, substantiation of initial principles of mathematical simulation, creation of theoretical geological models, problems of elementary and coincidence in geology, and methodological substantiations of possibilities of any mathematical model to approximate geological models. The essense and significance of these problems are considered. The main task of mathematical geology is to prove its correspondence to the nature of the geological objects studied, geological data obtained, and geological problems solvable. Finally, the main problems of mathematical geology are not so much mathematical as geological and methodological. 相似文献
Ancient fluvial successions often act as hydrocarbon reservoirs. Sub‐surface data on the alluvial architecture of fluvial successions are often incomplete and modelling is performed to reconstruct the stratigraphy. However, all alluvial architecture models suffer from the scarcity of field data to test and calibrate them. The purposes of this study were to quantify the alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands) and to determine spatio‐temporal trends in the architecture. Five north–south orientated cross‐sections, perpendicular to the general flow direction, were compiled for the fluvial‐dominated part of the delta. These sections were used to calculate the width/thickness ratios of fluvial sandbodies (SBW/SBT) and the proportions of channel‐belt deposits (CDP), clastic overbank deposits (ODP) and organic material (OP) in the succession. Furthermore, the connectedness ratio (CR) between channel belts was calculated for each cross‐section. Distinct spatial and temporal trends in the alluvial architecture were found. SBW/SBT ratios decrease by a factor of ca 4 in a downstream direction. CDP decreases from ca 0·7 (upstream) to ca 0·3 (downstream). OP increases from less than 0·05 in the upstream part of the delta to more than 0·25 in the downstream delta. ODP is approximately constant (0·4). CR is ca 0·25 upstream, which is approximately two times larger than in the downstream part of the delta. Furthermore, CDP in the downstream Rhine–Meuse delta increases after 3000 cal yr BP. These trends are attributed to variations in available accommodation space, floodplain geometry and channel‐belt size. For instance, channel belts tend to narrow in a downstream direction, which reduces SBW/SBT, CDP and CR. Tectonics cause local deviations in the general architectural trends. In addition, the positive correlation between avulsion frequency and the ratio of local to regional aggradation rate probably influenced alluvial architecture in the Rhine–Meuse delta. The Rhine–Meuse data set can be a great resource when developing more sophisticated models for alluvial architecture simulation, which eventually could lead to better characterizations of hydrocarbon reservoirs. To aid such usage of the Rhine–Meuse data set, constraints for relevant parameters are provided at the end of the paper. 相似文献
We designed a new seismic source model for Italy to be used as an input for country-wide probabilistic seismic hazard assessment (PSHA) in the frame of the compilation of a new national reference map.
We started off by reviewing existing models available for Italy and for other European countries, then discussed the main open issues in the current practice of seismogenic zoning.
The new model, termed ZS9, is largely based on data collected in the past 10 years, including historical earthquakes and instrumental seismicity, active faults and their seismogenic potential, and seismotectonic evidence from recent earthquakes. This information allowed us to propose new interpretations for poorly understood areas where the new data are in conflict with assumptions made in designing the previous and widely used model ZS4.
ZS9 is made out of 36 zones where earthquakes with Mw > = 5 are expected. It also assumes that earthquakes with Mw up to 5 may occur anywhere outside the seismogenic zones, although the associated probability is rather low. Special care was taken to ensure that each zone sampled a large enough number of earthquakes so that we could compute reliable earthquake production rates.
Although it was drawn following criteria that are standard practice in PSHA, ZS9 is also innovative in that every zone is characterised also by its mean seismogenic depth (the depth of the crustal volume that will presumably release future earthquakes) and predominant focal mechanism (their most likely rupture mechanism). These properties were determined using instrumental data, and only in a limited number of cases we resorted to geologic constraints and expert judgment to cope with lack of data or conflicting indications. These attributes allow ZS9 to be used with more accurate regionalized depth-dependent attenuation relations, and are ultimately expected to increase significantly the reliability of seismic hazard estimates. 相似文献
The imbalance between incoming and outgoing salt causes salinization of soils and sub-soils that result in increasing the
salinity of stream-flows and agriculture land. This salinization is a serious environmental hazard particularly in semi-arid
and arid lands. In order to estimate the magnitude of the hazard posed by salinity, it is important to understand and identify
the processes that control salt movement from the soil surface through the root zone to the ground water and stream flows.
In the present study, Malaprabha sub-basin (up to dam site) has been selected which has two distinct climatic zones, sub-humid
(upstream of Khanapur) and semi-arid region (downstream of Khanapur). In the upstream, both surface and ground waters are
used for irrigation, whereas in the downstream mostly groundwater is used. Both soils and ground waters are more saline in
downstream parts of the study area. In this study we characterized the soil salinity and groundwater quality in both areas.
An attempt is also made to model the distribution of potassium concentration in the soil profile in response to varying irrigation
conditions using the SWIM (Soil-Water Infiltration and Movement) model. Fair agreement was obtained between predicted and
measured results indicating the applicability of the model. 相似文献
Landslides are very common natural problems in the Black Sea Region of Turkey due to the steep topography, improper use of
land cover and adverse climatic conditions for landslides. In the western part of region, many studies have been carried out
especially in the last decade for landslide susceptibility mapping using different evaluation methods such as deterministic
approach, landslide distribution, qualitative, statistical and distribution-free analyses. The purpose of this study is to
produce landslide susceptibility maps of a landslide-prone area (Findikli district, Rize) located at the eastern part of the
Black Sea Region of Turkey by likelihood frequency ratio (LRM) model and weighted linear combination (WLC) model and to compare
the results obtained. For this purpose, landslide inventory map of the area were prepared for the years of 1983 and 1995 by
detailed field surveys and aerial-photography studies. Slope angle, slope aspect, lithology, distance from drainage lines,
distance from roads and the land-cover of the study area are considered as the landslide-conditioning parameters. The differences
between the susceptibility maps derived by the LRM and the WLC models are relatively minor when broad-based classifications
are taken into account. However, the WLC map showed more details but the other map produced by LRM model produced weak results.
The reason for this result is considered to be the fact that the majority of pixels in the LRM map have high values than the
WLC-derived susceptibility map. In order to validate the two susceptibility maps, both of them were compared with the landslide
inventory map. Although the landslides do not exist in the very high susceptibility class of the both maps, 79% of the landslides
fall into the high and very high susceptibility zones of the WLC map while this is 49% for the LRM map. This shows that the
WLC model exhibited higher performance than the LRM model. 相似文献